REMOVING GEAR
CASE
1.
Remove
the gear case
cover.
2.
Remove the O-ring.
NOTE FOR REASSEMBLING: Check
to
see
if there are three O-rings inside the gear
case.
Apply
a thin film of engine
to
the oil seal, and install
it,
noting the lip come off. Before installing the gear
case gasket,
apply a non-drying adhesive. Tighten the oil filter cartridge
by
hand.
REMOVING CRANKSHAFT OIL SLINGER
1.
Remove
the crankshaft collar.
2.
Remove
the O-ring.
3.
Detach the crankshaft oil slinger.
1. Crankshaft Oil Slinger
2.
O-Ring
3. Crankshaft Collar
115
To Next Page
Loading...
