GENERAL WARNINGS
• When disassembling engine, arrange each part
on
a clean surface.
Do
not mix them
up.
Replace bolts and nuts
in
their original positions.
• When servicing voltaged parts or connecting instruments
to
electrical equipment, first
disconnect negative battery
terminal.
• Replace
gaskets or O-rings with new ones when disassembling, and apply grease
on
the
0-
ring and the oil seal when reassembling.
• When
exchanging parts, use Universal genuine parts to maintain engine performance and
safety.
•
To
prevent oil and water leakage apply non-drying adhesive to the gasket according to this
manual before reassembling.
•
When hoisting the engine, use the hook provided
on
the cylinder head.
• When installing external circlips or internal circlips, direct corner end
to
the non-loosening
direction.
Applying
grease
to
oil seal
Direction
of
installing circlips
3
F-
1
5
1.
Inside
of
Lip
2. Grease
3.
External Circlip
4.
Internal Circlip
5.
Direct the Corner End
to
the Direction Subject to Force.
40
4
5
To Next Page
Loading...
Need help?
General
