Copying Functions
4-10
Paper Output
You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
The table below shows the available output destinations.
Use the procedure below to select the output destination.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Org./Paper/Finishing] and then [Paper
Output].
4 Select the output destination for finished copies.
5 Press [OK].
6 Press the Start key to start copying.
NOTE: Optional output destinations include the document finisher.
Destination Description
Inner tray*
* This cannot be selected when the optional document finisher is installed.
Inner tray of the machine
Job Separator Tray Job separator tray
Finisher Tray Tray of the optional document finisher
NOTE: To change the default destination for copies, refer to Paper Output on page 9-15 for details.
To Next Page
Loading...
