Management
10-17
10
Simple Login Settings
Simple login makes it possible to log in by simply selecting a user. The user must be previously registered.
Simple Login
Select whether or not simple login is enabled.
Use the procedure below.
1 Press the System Menu key.
2 Press [User Login/Job Accounting].
3 If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. The login user name and
login password are both set to "2500" in the factory
default state.
4 Press [Next] of User Login Setting, [Next] of Simple
Login Settings, and then [Change] of Simple Login.
5 Select [On] or [Off].
6 Press [OK].
Simple Login Key
Register a user for simple login. You can add Up to 20 users.
Use the procedure below.
1 Press the System Menu key.
2 Press [User Login/Job Accounting].
3
If the user authentication screen appears, enter your
login user name and password and then press
[Login]. For this, you need to login with administrator
privileges. The login user name and login password
are both set to "2500" in the factory default state.
NOTE: For user registration, refer to Adding a User (Local User List) on page 10-5.
To use Simple Login, User Login Administration must be enabled in User Login on page 10-2.
If the guest authentication setting is enabled, Simple login cannot be enabled.
To Next Page
Loading...
