Management
10-10
Unknown ID Job
This specifies the behavior for handling the jobs sent with unknown login user names or User ID (i.e. unsent
IDs). If the User Login is set to invalid and Job Accounting is set to valid, follow the procedure when the Account
ID is unknown.
The table below shows the available settings.
Use the procedure below to process jobs sent from unknown users.
1 Press the System Menu key.
2 Press [User Login/Job Accounting].
3 If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. The login user name and
login password are both set to "2500" in the factory
default state.
4 Press [Change] of Unknown ID Job.
5 Press [Reject] or [Permit].
6 Press [OK].
Group Authorization Set.
Set restrictions of the machine usage by each individual group registered in the authentication server.
Group Authorization
Use the group authorization.
Use the procedure below.
1 Press the System Menu key.
2 Press [User Login/Job Accounting].
3 If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. The login user name and
login password are both set to "2500" in the factory
default state.
4 Press [Next] of User Login Setting, [Next] of Group
Authorization Set., and then [Change] of Group
Authorization.
5 Press [On].
6 Press [OK].
Item Description
Reject The job is rejected (not printed).
Permit The job is permitted to be printed.
NOTE: To use the group authorization settings, [Network Authentication] must be selected for the
authentication method and [NTLM] or [Kerberos] must be selected as the server type in User Login on page
10-2. Select [On] for LDAP in Protocol Detail on page 9-98.
To Next Page
Loading...
Need help?
General
