Document Box
7-2
Using a Custom Box
Creating a New Custom Box (Add/Edit Box)
Use the procedure below to create a new box in the user box.
1 Press the Document Box key.
2 Press [Custom Box] and then [Add/Edit Box].
3 Press [Add].
4 Press [Change] for each item, enter the information
and then press [OK].
The table below lists the items to be set.
NOTE: In the following explanation, it is assumed that user login administration is enabled. For details on
User Logon privileges, refer to User Privileges on page 3-49.
Item Detail
Box No. Enter the box number by pressing [-, +] or number keys.
The box number can be from 0001 to 1000. A Custom Box should have a unique
number. If you enter 0000, the smallest number available will be automatically
assigned.
Box Name Enter a box name consisting of up to 32 characters.
Refer to the Character Entry Method on Appendix-6 for details on entering
characters.
Box Password User access to the box can be restricted by specifying a password to protect the
box. Entering a password is not mandatory.
Enter the same password of up to 16 characters in both [Password] and [Confirm
Password].
Usage Restriction To preserve the hard disk capacity, the storage capacity for a box can be restricted.
To enable a capacity restriction enter a value for the storage capacity of the Custom
Box in megabytes by pressing [-, +] or number keys.
You can enter a limit between 1 and 30,000. (Changes according to the number of
created custom boxes.)
To Next Page
Loading...
Need help?
General
