Sending Functions
6-7
6
Centering
When you have scanned the original after specifying the original size and sending size, depending on these
sizes, a margin is created at the bottom, left, or right side of paper. This feature can be used to center the image
so that the left and right margins and the top and bottom margins are equal.
Use the procedure below to center the image when sending a scanned image.
1 Press the Send key.
2 Place the originals on the platen.
3 Press [Advanced Setup] and then [Centering].
4 Press [On]. Centering is performed.
5 Press [OK].
6 Specify the destination, and press the Start key to
start sending.
To Next Page
Loading...
