DE35-ST Operating Instructions
D292469I 9
Machine Setup & Installation
The DE35 ST Die Pick and Place System is intended to be installed in a facility meeting
the listed environmental requirements unless otherwise specified in a particular section.
• Indoor use
• Altitude up to 2000 meters
• 60 to 70 degrees Fahrenheit
• Maximum Relative Humidity of 10 to 90 percent, non- saturating.
• Main supply voltage fluctuations not to exceed ±10% of nominal voltage.
• Transient over-voltages according to installation categories: Over voltage
Categories II
• Pollution Degree 2
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
To Next Page