88 D292469I
Adjust the Inverter Flexure
The Inverter Flexure is the portion of the Die Inverter that receives the previously picked
die. This flexure will bend downward as the die is being transferred from the Pickup Tip.
The position of the Flexure is adjusted using a nylon tipped set screw. This position
should be adjusted so that the Flexure Tip is level or planar with the Inverter Pickup Tip.
Please see picture above.
Adjust Inverter Z & Y Position
The Die Inverter is mounted on a precision slide assembly. Both Axis Adjustment Screws
are locked in place.
1. Loosen the Lockdown Screws before adjusting.
2. The Z Axis is adjusted by turning the Adjustment Screw clockwise for DOWN and
counter clockwise for UP.
The Y Axis is adjusted by turning the Adjustment Screw clockwise to move the
stage to the BACK of the machine and counter clockwise to move the stage to
the FRONT of the machine.
3. Secure the Lock-Down Screws once the alignment is completed.
To Next Page
Loading...