DE35-ST Operating Instructions
D292469I 49
X Output Grades
This line when active allows you to choose from 1, 2, 3 or 4 grades for your
output when using any 4-pack configuration. You can choose 1 or 2 grades when
using any 2-pack configuration.
When using grades, pressing OUTPUT LOAD/UNLOAD after placing a Die will
move the table out to the load/unload position allowing you to replace that tray
without affecting the count of the other grades.
When reaching the full count for a grade, the table will automatically move to
the load/unload position to replace trays for that grade, pressing YES will resume
operation. Only the grade affected will have the count reset.
Note: The number of trays listed will depend on the number of trays/substrates
available for the programmed output fixture. For example, if a 4 tray fixture is
selected, four output trays will be listed.
By default all trays are set to Grade 1. To assign a different grade to a tray, move
the > so it points at the desired tray, press Yes to make active, then use the +/-
buttons on the keypad until the desired grade is shown. Press Yes to save.
Each tray can be assigned a different grade, all trays can be assigned the same
grade, or each tray can be assigned a grade. The system will not allow more
grades than the number of trays available on the output fixture.
Placement Pattern: Full/Checkerboard
This line toggles between FULL and CHECKERBOARD.
FULL: Die will be placed in every position of the Output device until full or
the specified Die count is reached.
CHECKERBOARD: Die will be placed into a checkerboard pattern in the
Output device until full or the specified die count is reached.
SKIP FIRST AND LAST: Die will be placed in every position of the Output
device except for the first pocket and last pocket of each tray.
Synchronized Die Lift: Yes/No
When Synchronized Die Lift is set to Yes, the Pickup tip will lift as the Die Eject
needle rises. This will only function if the system has a motorized Eject Actuator
installed.
To Next Page
Loading...