46 D292469I
The OUTPUT SIZES menu is used to Calibrate Trays, Clear Trays and to select the Pattern
Number for the output tray.
• Enter the Pattern number of the waffle pack being used.
o If it is a programmed pattern number the dimensions will automatically
be called up.
o If the number is not programmed the display will flash New Pattern
Number. Enter the X and Y PITCH, and the X and Y COUNT to be used for
the output pattern.
o Once saved, the information will be available for future use and will
display Custom on the LCD when this part number is loaded.
o Once the output is programmed, calibrate the trays to insure proper
placement of the Die.
Output Select
To open the menu, press the OUTPUT SELECT key. The menu has many options,
however, only two lines will be displayed at a time. Press the YES key with the curser >
in front of any menu item to select that item. If the option selected changes a
previously selected option, the previous selection will be de-selected. Below are the
menu items and function in the order they will appear on the LCD.
NOTE: The menu items may be slightly different depending on your specific
options and software version.
Quit Menu
This line allows you to quit this menu and exit back to the main program by
pressing the YES key.
Process Recipe
Process Recipe allows the selection of nine possible recipes.
The recipe contains all the information contained in the OUTPUT SELECT menu
and the OUTPUT SIZES menu. When a RECIPE is loaded you can step through
the menus and set up the process.
To Next Page
Loading...