112 D292469I
Adjusting Pickup Height at the Pick Position
1. Turn the DE35 OFF.
2. Lower the Eject Head to its lowest height.
3. Turn the DE35 ON and allow it to reset.
4. Install sample into the work holder.
5. Position a die sample over the Eject Head.
6. Press SINGLE STEP.
7. Press the Foot Switch until the pickup arm lowers to the pick position and the
LCD displays TURN ON PICKUP VACUUM.
8. Press the COARSE/FINE key so that the LCD also says FINE.
9. Press the DOWN key until the display reads REACHED LIMIT.
10. Raise the Eject Head up until the display reads PICKUP IN CONTACT.
11. Press the UP key until the display reads PICKUP CLEAR by one fine step.
12. Press SINGLE STEP to return to normal operation. The machine will now lower to
this height during normal operation.
Adjust Pickup Height at Place Positions
1. Turn ON the DE35 ST and let it reset.
2. Install a sample into the work holder.
3. Position a die sample over the Eject Head.
4. Press SINGLE STEP.
5. Press the Foot Switch until a die is picked, the tip is over the Waffle Pack and the
LCD displays TURN OFF PICKUP VACUUM.
6. Press the COARSE/FINE key so the LCD displays FINE.
7. Press the DOWN key until the LCD displays PICKUP IN CONTACT by one fine step.
NOTE: If the LCD displays PICKUP IN CONTACT when moving to this position,
press the UP key until the LCD displays PICKUP CLEAR, then perform step seven.
8. Press SINGLE STEP to return to normal operation.
9. The machine will now lower to this height during normal operation
To Next Page
Loading...