DE35-ST Operating Instructions
D292469I 5
Adjusting the Die to the Pickup Tip: DE35-ST 81
Die Inverter System 83
Die Inverting Cycle 84
Die Inverting Discussion 86
Adjust Die Inverter Home Position 87
Adjust the Inverter Flexure 88
Adjust Inverter Z & Y Position 88
Non-Surface Contact Operation 89
Non-Surface Contact Pickup Cycle 89
Edge Pick Up 91
Adjust Pickup Grippers 92
Replace Gripper Fingers 93
Die Underside Inspection 95
Adjust Pickup Tip Height at Underside Inspection 95
Underside Inspection Cycle 96
Die Facet Inspection 97
Adjust Pickup Tip Height at Facet Inspection 97
Adjust Die Position on Rotating Spindle at Facet Inspection 97
Facet Inspection Cycle 99
Wafer Holders 100
Wafer Holder Interlock 101
Film Frame Holders 102
Operation of Expanding Film Frame Holder 102
Ring Holders 103
Operation of Expanding Ring Holder 103
DES-AUM Die Eject Actuator 105
Adjust Needle Speed & Height 105
Basic Troubleshooting & Maintenance 107
To Next Page
Loading...