Vacon 100 flow User Manual

Commissioning vacon • 13
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
4
4. COMMISSIONING
The integrated EtherNet/IP protocol in the VACON® 100 Family AC drive must be selected when or-
dering the drive. If the drive is not equipped with the integrated EtherNet/IP protocol, the EtherNet/
IP menus do not appear and the protocol cannot be used.
EtherNet/IP is configured from panel or with VACON® Live. Settings for EtherNet/IP can be found
under “I/O and Hardware / Ethernet / EtherNet/IP”. EtherNet/IP has two menus, one for parameters
and one for monitoring. If the protocol has been disabled, the monitoring menu is not shown on pan-
el.
In addition to settings below, EtherNet/IP uses common network settings (i.e. IP address, network
mask, etc.).
Basic information on how to use the control keypad you can find in the VACON 100 INDUSTRIAL Ap-
plication Manual. See chapter 10 for information on how to configure the VACON ® 100 drive to be
controlled from fieldbus.
4.1 EtherNet common settings
4.1.1 IP Address mode
The selectable alternatives are DHCP (Dynamic Host Configuration Protocol) and Fixed. DHCP pro-
tocol gives IP addresses to new devices connecting to the local network. If the AC drive is unable to
retrieve its IP settings, it will set a link-local address as the current IP address after about one min-
ute (for example 169.x.x.x).
Table 3. EtherNet common settings
Panel Tree Parameter Range Default ID Description
P5.9.1.1 IP address mode
Fixed (1),
DHCP(2)
DHCP(2) 2482 IP Mode
P5.9.1.2 Duplicate IP Detection
Disabled (0),
Enabled (1)
enabled 2569
This is setting for enabling ACD
(See Chapter 2.1.1). When
disabled drive does not check
for or react to address conflict
situation.
P5.9.1.3.1 IP address
1.0.0.0 -
223.255.255.255
192.168.0.10 2529 Fixed IP address
P5.9.1.3.2 Subnet mask
0.0.0.0-
255.255.255.255
255.255.0.0 2530 Fixed Subnet mask
P5.9.1.3.3 Default gateway
0.0.0.0-
255.255.255.255
192.168.0.1 2531 Fixed default gateway
P5.9.1.4 Active IP address - - 2483
Shows current active IP
address. It is same as fixed
value if IP mode is "Fixed".
P5.9.1.5 Active subnet mask - - 2484
Shows current active subnet
mask. It is same as fixed value if
IP mode is "Fixed".
P5.9.1.6 Active default gateway - - 2485
Shows current active default
gateway. It is same as fixed
value if IP mode is "Fixed".
P5.9.1.7 MAC address - - 2486 Drive MAC address

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V