54 • vacon description of parameters
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
7
454 Motor regulator activation
(2.3.3.22)
Overvoltage or overcurrent regulator has been activated.
455 Fieldbus input data 1 (FBFixedControlWord, bit 3)
(2.3.3.23)
456 Fieldbus input data 2 (FBFixedControlWord, bit 4)
(2.3.3.24)
457 Fieldbus input data 3 (FBFixedControlWord, bit 5)
(2.3.3.25)
The data from the fieldbus (FBFixedControlWord) can be led to frequency converter
digital outputs.
463 Analogue input supervision limit
(2.3.3.)
The selected analogue input signal goes beyond the set supervision limits (see
parameters ID372, ID373 and ID374).
464 Analogue output 1 signal selection
(2.3.5.1)
Connect the AO1 signal to the analogue output of your choice with this parameter. For
more information about the TTF programming method, see chapter 5 on page 10.
471 Analogue output 2 signal selection
(2.3.6.1)
Connect the AO2 signal to the analogue output of your choice with this parameter. For
more information about the TTF programming method, see chapter 5 on page 10.
472 Analogue output 2 function
(2.3.6.2)
473 Analogue output 2 filter time
(2.3.6.3)
474 Analogue output 2 inversion
(2.3.6.4)
475 Analogue output 2 minimum
(2.3.6.5)
476 Analogue output 2 scaling
(2.3.6.6)
For more information on these five parameters, see the corresponding parameters for
the analogue output 1 on pages 40 to 42.
477 Analogue output 2 offset
(2.3.6.7)
Add –100.0 to 100.0% to the analogue output.
478 Analogue output 3, signal selection
(2.3.7.1)
See ID464.
479 Analogue output 3, function
(2.3.7.2)
See ID307.
480 Analogue output 3, filter time
(2.3.7.3)
See ID308.
481 Analogue output 3 inversion
(2.3.7.4)
See ID309.
To Next Page
Loading...
Need help?
General
