description of parameters vacon • 55
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
482 Analogue output 3 minimum
(2.3.7.5)
See ID310.
483 Analogue output 3 scaling
(2.3.7.6)
See ID311.
484 Analogue output 3 offset
(2.3.7.7)
See ID375.
485 Torque limit
(2.2.4.2)
See par. ID399 for the selections.
486 Digital output 1 signal selection
(2.3.1.1)
Connect the delayed DO1 signal to the digital output of your choice with this parameter.
For more information about the TTF programming method, see chapter 5 on page 10.
487 Digital output 1 on-delay
(2.3.1.3)
488 Digital output 1 off-delay
(2.3.1.4)
With these parameters you can set on- and off-delays to digital outputs.
Figure 17. Digital outputs 1 and 2, on- and off-delays
489 Digital output 2 signal selection
(2.3.2.1)
See ID486.
490 Digital output 2 function
(2.3.2.2)
See ID312.
491 Digital output 2 on-delay
(2.3.2.3)
See ID487.
492 Digital output 2 off-delay
(2.3.2.4)
See ID488.
NX12k102
ON-delay OFF-delay
Signal programmed to
digital output
DO1 or DO2 output
To Next Page
Loading...
Need help?
General
