Vacon X5 - Page 66

X5 AC Drive User’s Manual Chapter 6: Using Macro Mode / Quick Start
DPD00089A - 64 - © 2009 Vacon Incorporated All Rights Reserved
Table 6-2: Fan Application Macro (Core Factory Application from Table 6-1, plus the following parameters)
Para. # Parameter Name Default See Page
203 Stop Key Remote Coast 76
204 Ref Select Vin1 76
205 Vin1 Config 0-10 V 77
206 Vin1 Offset 0.00% 77
207 Vin1 Span 100.00% 77
406 DC Inject Config DC at Start 82
501 V/Hz Select Fan Fxd 85
504 Skip Freq Band 0.2 Hz 86
505 Skip Freq 1 0.0 Hz 86
608 Restart Number 0 90
609 Restart Delay 60 sec 90
702 Imet Config Current Out 92
703 Imet Span 100.0% 92
704 Imet Offset 0.0% 92
721 DI1 Configure Preset 1 95
722 DI2 Configure Preset 2 95
723 DI3 Configure Preset 3 95
724 DI4 Configure Ref Switch 95
725 DI5 Configure Fault Reset 95
803 PWM Frequency 16.0 kHz 100
804 Display Mode Output Freq 100