Vacon X5 - Page 69

X5 AC Drive User’s Manual Chapter 6: Using Macro Mode / Quick Start
DPD00089A - 67 - © 2009 Vacon Incorporated All Rights Reserved
Table 6-5: Pump with PI Application Macro (Core Factory Application from Table 6-1, plus the following
parameters)
Para. # Parameter Name Default See Page
203 Stop Key Remote Coast 76
204 Ref Select Vin1 76
205 Vin1 Config 0-10 V 77
206 Vin1 Offset 0.00% 77
207 Vin1 Span 100.00% 77
208 Cin Config 0-20 mA 50 77
209 Cin Offset 0.0% 77
210 Cin Span 100.0% 78
211 Vin2 Config 0-10 V 78
212 Vin2 Offset 0.00% 78
213 Vin2 Span 100.00% 78
401 Ramp Select ART-Strt/RS 81
406 DC Inject Config DC at Stop 82
501 V/Hz Select Pump Fxd 85
504 Skip Freq Band 0.2 Hz 86
505 Skip Freq 1 0.0 Hz 86
608 Restart Number 0 90
609 Restart Delay 60 sec 90
702 Imet Config Current Out 92
703 Imet Span 100.0% 92
704 Imet Offset 0.0% 92
721 DI1 Configure Preset 1 95
722 DI2 Configure Preset 2 95
723 DI3 Configure Preset 3 95
724 DI4 Configure Ref Switch 95
725 DI5 Configure PI Enable 95
803 PWM Frequency 16.0 kHz 100
804 Display Mode Output Freq 100
850 PI Configure No PI 102
851 PI Feedback Vin1 102
852 PI Prop Gain 0 102
853 PI Int Gain 0 102
854 PI Feed Gain 1000 102
857 PI High Corr 100.00 102
858 PI Low Corr 0.00% 103