Camera Configuration
Keep in mind that the OneLINK HDMI displays its own IP address, not the camera's IP address.
Point the remote at the camera and press the Data Screen button to see the camera's IP address on the
connected display.
You can configure the following settings on your Vaddio HDBaseT camera:
n HDMI output resolution: Depending on the camera, set this using the rotary switch on the back of the
camera or the virtual rotary switch on DIP Switches tab of the System page.
n IP streaming: Streaming page. Settings include Enable/disable, streaming quality, and streaming
resolution.
n Codec Control Mode: Soft DIP on the DIP Switches tab of the System page.
n IR: ON (default). DIP switch 3 on the back of RoboSHOT 20 UHD or RoboSHOTHDBT cameras, soft
DIP 3 on the DIP Switches tab of the System page for DocCAM 20 HDBT.
Note
Codec Control Mode was added to Vaddio cameras in early 2018. Your camera may require a firmware
update to add this capability.
21
Integrator's Complete Guide to the OneLINK HDMI Camera Extension
To Next Page
Loading...
