12.2.2 LED description
Description Symbol Color Operation Description
Information Blue On The system or area cannot be set. Forced setting is possible
(faults or open zones can be inhibited).
Flashing The system or area cannot be set or forced set (faults or open
zones cannot be inhibited).
Off The system or area can be set.
Amber Flashing Engineer is on site.
User Green On Assigned area is unset.
Flashing Assigned area is Partset A/B
Off Assigned area is fullset
Alarm Red On Alarm
Flashing -
Off No alarm
Alert Amber On -
Flashing Trouble
Off No trouble
Mains Green On System ok
Flashing Mains fault
Off No bus connection
NOTICE:The LED indications for information, area status, alarm and fault is deactivated in idle
state of the keypad. A valid user PIN has to be entered. It is configurable if the power indication
can be seen in idle state.
12.2.3 Viewing mode description
There are 2 viewing modes (automatic):
l Multi area view: User has access to several areas. Displaying the areas is done via area groups.
If no area group is configured, only the general group “All my areas” is displayed.
l Single area view: The user has only rights for 1 area. In the single area view, only one area is
displayed in large fonts and can be controlled directly.
The rights of a user can be restricted by the user settings or the settings of the keypad the user is
logging in to. Only if the user and the keypad that is being used for logging in have the right for an
area, the area is displayed. If the user has the right for several areas but the keypad has only the
right for one area, the user will also see the single area view.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Keypad user interface
© Vanderbilt 2018 103 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
