CODE CID EVENT DESCRIPTION
300 SYSTEM TROUBLE PSU fault and restore.
301 AC LOSS PSU mains fail and restore.
302 BATTERY LOW
305 RESET System reset.
311 BATTERY FAIL PSU battery fail and restore.
312 PSU OVERCURRENT PSU internal, external and auxiliary fuse fail and restore.
320 SOUNDER Bell tamper fail and restore.
330 SYSTEM PERIPHERAL
TROUBLE
PSU fault and restore.
333 EXP FAIL X-Bus cable and node communications fault and restore.
338 EXP BATT X-Bus node battery fault and restore.
341 EXP TAMPER X-Bus tamper and RF antenna tamper alarm and restore.
342 EXP AC X-Bus node mains fault and restore.
344 RF JAM RF jam fault and restore.
351 TELCO 1 Primary modem fault and restore.
352 TELCO 2 Secondary modem fault and restore.
376 HOLDUP TROUBLE
380 SENSOR TROUBLE
401 OPENCLOSE Unset, post alarm and fullset.
406 ALARM ABORT Cancel alarm.
451 EARLY OPENCLOSE
452 LATE OPENCLOSE
453 FAIL TO OPEN Late to unset.
454 FAIL TO CLOSE Late to set.
456 EVENT PARTSET Partset A and B.
461 CODETAMPER User code tamper.
466 SERVICE Engineer mode enabled and disabled.
570 BYPASS Zone inhibited and uninhibited, zone isolated and un-isolated.
601 MANUAL TEST Modem manual test.
602 AUTO TEST Modem automatic test.
607 WALK TEST
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Appendix
© Vanderbilt 2018 374 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
