A prompt to select a zone type is displayed.
6. Scroll to the required zone type and press OK.
Edit Sensors (Zone Assignment)
It may be necessary to change the zone assignment of a sensor enrolled on the system.
To change the zone assignment of a wireless detector:
1. Scroll to EDIT and press OK.
2. Scroll to the sensor to be changed and press OK.
3. Scroll to ZONE and press OK.
4. Scroll to the appropriate zone number (only unoccupied zone numbers are displayed) and press
OK.
16.9.3.2 WPAN personal alarm button
The WPAN personal alarm button is a device that is used to transmit Panic Alarm messages to the
SPC system.
The user can wear the WPAN in one of two ways:
l WPAN can be worn as a wrist watch (by inserting the wrist band into the two slits of the
appropriate ring holder).
l WPAN can be worn as a pendant by removing the wrist ring holder and replacing it with the
pendant ring holder.
Enrol a WPAN personal alarm button
To enrol the WPAN and assign it to a User(n):
1. Select USERS > EDIT > USER(n) > RF FOB > ENABLED.
The keypad displays the ADD screen with a flashing ENROL DEVICE message.
2. On the WPAN, press and hold the button.
The LEDs on the fob light in the following pattern: Red lights for 3 seconds, then no LED, then
Red lights for 1 second, and then Green lights for 1 second. The WPAN is assigned to User (n).
Disable a WPAN personal alarm button
To disable the WPAN:
Select USERS > EDIT > USER(n) > RF FOB > DISABLED.
A message appears on-screen saying UPDATED.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 146 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
