16.9.3.3 WRMT remote control
The WRMT 4-button Remote is a device which allows a user to remotely operate the SPC system. The
device supports UNSET, FULLSET, and PARTSET functionality, as well as the operation of defined
outputs and an SOS feature.
1 Fullset
2 Partset
3 Unset
4 Output
5 Panic/SOS
6 LED
Enrol a WRMT remote control
To enrol the WRMT and assign it to a User (n):
1. Select USERS > EDIT > USER (n) > RF FOB > ENABLED.
The keypad displays the ADD screen with a flashing ENROL DEVICE message.
2. On the WRMT, press and hold the two SOS buttons.
The LED blinks Red once and then Green to confirm enrolment. A message appears on the keypad
screen saying FOB CONFIGURED. The WRMT is assigned to the User (n).
Disable a WRMT remote control
To disable a WRMT:
l Select USERS > EDIT > USER (n) > RF FOB > DISABLED.
A message appears on-screen saying UPDATED.
When you disable a WRMT from your system, you must also clear the internal registration in the WRMT
before you can re-use the WRMT.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 147 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
