3. Click the Add button to assign the IRCW6-11 to the user.
4. On the Edit user settings page click Save.
Delete a IRCW6-11 remote control
To delete a IRCW6-11:
1. Go to Configuration > Hardware > Wireless > Transceiver list.
2. Click the Delete button beside the IRCW6-11 that you want to delete.
17.9.1.5 Changing wireless settings
To change wireless settings, select Configuration > Hardware > Wireless > Wireless Settings.
See table below for further information.
Two Way
Wireless
Enable or disable two-way wireless depending on the transceiver you are using.
Enable two-way wireless if you are using SPCW120 Wireless Transceiver.
Disable two-way wireless if you are using SiWay RF Kit (SPCW110, 111, 112, 114 ).
Filter Click to filter low strength RF signals.
Detect RF
JAM
Click to activate an alert if RF interference is detected.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 218 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
