To Next Page

To Previous Page

Setting

state

Select if setting state should be indicated in idle mode.

Audible Indications

Buzzer Enable or disable the buzzer on the keypad.

Partset

Buzzer

Enable or disable buzzer during exit time on Partset.

Keypress Select if the speaker volume for the key presses should be activated.

Deactivation

Calendar Select if the keypad should be limited by calendar. See Calendars on page284.

Mapping

gate

Select if keypad should be limited by a mapping gate.

Keyswitch Select if keypad should be limited by a keyswitch.

PACE

Entry

Tick this box to disable the keys on the keypad during the entry time when a

PACE is configured on the keypad.

Areas

Location Select the secured area where the keypad is located.

Areas Select which areas can be controlled through keypad.

Options

Delay

Fullset

Select to configure a delayed set across all keypads. The location of the keypad

is ignored and all areas will perform a full exit time count down.

NOTICE: An area should be assigned to a keypad only if the keypad is inside the assigned area,

and if an entry/exit route is defined. If an area is assigned, when the particular area is set or unset

then entry and exit timers are used (if configured). Other features related to entry/exit routes also

become available. If no area is assigned, the area is set or unset immediately and other entry/exit

features are not available.

Vanderbilt SPCA210.100 User Manual

Questions and Answers: