Vanderbilt SPCA210.100 User Manual

Test Calls
Test Call Mode
(Non-active
ATP)
Select the mode for sending test calls when the ATP is in non-active
mode. Default: 24 hours.
l Test calls disabled
l Test call every 10 minutes
l Test call every 1 hour
l Test call every 24 hours
l Test call every 48 hours
l Test call every 7 days
l Test call every 30 days
Test Call Mode
(Active ATP)
Select the mode for sending test calls when the ATP is an active ATP.
Default: 24 hours.
l Test calls disabled
l Test call every 10 minutes
l Test call every 1 hour
l Test call every 24 hours
l Test call every 48 hours
l Test call every 7 days
l Test call every 30 days
Time of first
test call
Time of first test call after reset or ATS initialization.
l Send Immediately (default)
or
l Select a half hour interval between 00:00 and 23:30
Event Protocol
Protocol Protocol used in communication.
l SIA
l SIA Extended 1
l SIA Extended 2
l Contact ID
Event Profile Select the Event Profile which defines how and which events are
transmitted on this ATS.
l Use ATS Setting
l Default Event Profile
l Default Portal Event Profile
l All events
l Custom Event Profile
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 315 A6V10276959-d
11.2018

Vanderbilt SPCA210.100 Specifications

General

Brand	Vanderbilt
Model	SPCA210.100
Category	Power Supply
Language	English