17.11.3.1 Alarm Reporting Centres (ARCs)
The SPC panel has the facility to communicate information to a remote receiving station when a
specific alarm event on the panel has occurred.
These Alarm Reporting Centres must be configured on the panel to allow this remote communication to
operate.
Adding/Editing an ARC using SIA or CID
Prerequisite
o
PSTN or GSM modem is installed and functioning correctly.
1. Select Communications > Reporting > Analog ARC.
The following page will be displayed:
2. Click the Modem1/2 button to make a test call to the ARC from the either modem 1 or modem 2.
3. Click the Log button to receive a log file. A page with the logs from all automatic and manual test
calls will be displayed.
4. To add or edit an ARC, click Add.
– OR -
Click Edit.
The following page will be displayed.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 324 A6V10276959-d
11.2018
To Next Page
Loading...