Amount of current from Aux output using two 24Ah batteries (SPC535x/635x)
COMMS
NONE (mA) PSTN (mA) GSM (mA) PSTN+GSM (mA)
Standby time
12 h 2205 2180 2165 2140
24 h 1650 1625 1610 1585
30 h 1250 1225 1210 1185
60 h 450 425 410 385
Amount of current from Aux output using a 27Ah battery (SPC535x/635x)
COMMS
NONE (mA) PSTN (mA) GSM (mA) PSTN+GSM (mA)
Standby time
12 h 1900 1875 1860 1835
24 h 775 750 735 710
30 h 550 525 510 485
60 h 100 75 60 35
Amount of current from Aux output using two 27Ah batteries (SPC535x/635x)
COMMS
NONE (mA) PSTN (mA) GSM (mA) PSTN+GSM (mA)
Standby time
12 h 2205 2180 2165 2140
24 h 1900 1875 1860 1835
30 h 1450 1425 1410 1385
60 h 550 525 510 485
Values listed as N/A indicate that the selected battery does not have the capacity to power the minimum
load of just the SPC controller for the given standby time. See Calculating the battery power requirements
on page364 for maximum load of devices and modules.
Only sealed cell valve regulated battery types to be used.
For EN compliance the supplied current needs to be supported by the battery for required stand by
time.
23.5 Domestic, Commercial and Financial mode default settings
This table gives the default zone name and types on the controller for each mode of operation. All zones on connected
expanders are be categorized as unused until explicitly configured by the installation engineer.
Feature Domestic mode Commercial mode Financial mode
Zone Names
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Appendix
© Vanderbilt 2018 366 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
