C
HAPTER
3. M
AINTENANCE
P
ROCEDURES
3-61
02.9628.0010 CONFIDENTIAL
7-Oct-97
Step 4. Remove solenoid assembly.
a. At solenoid clamp, loosen four 4-40x1/4"PPZ screws that
secure clamp to solenoid mounting plate and bulkhead and
slide solenoid out from under clamp. It is not necessary to
remove screws that secure clamp.
Step 5. Replace solenoid by doing Steps 2 thru 4 in reverse.
Step 6. Calibrate dashpots. Refer to Douser Dashpot Calibration
paragraph.
To Next Page
Loading...