VARILITE VL4 - Tilt Mechanism Removal and Replacement

3-76
V
ARI
*L
ITE
®
-
VL4
W
ASH
L
UMINAIRE
S
ERVICE
M
ANUAL
CONFIDENTIAL 02.9628.0010
7-Oct-97
3.3.4.7 Tilt Mechanism Removal and Replacement
Parts
:
1 EA ASSY, TILT MECHANISM (VL4) (22.4004.0001)
Tools
:
Screwdriver, Phillips #1
Screwdriver, Phillips #2
Nutdriver, 5/16 inch
Versilube
To remove and replace tilt mechanism:
Step 1. Remove power to luminaire.
Step 2. Remove 12, 6-32x5/16"PPB screws that secure head covers to
rails and remove both head covers (
Figure 3-1
).
Step 3. At yoke termination board, disconnect all connectors.
a. 4-pin connector from AMBER header marked YTB-P9.
b. 8-pin connector from AMBER header marked YTB-P8.
c. 4-pin connector from BLUE header marked YTB-P7.
d. 8-pin connector from BLUE header marked YTB-P6.
e. 4-pin connector from MAG header marked YTB-P11.
f. 8-pin connector from MAG header marked YTB-P10.
g. 4-pin connector from DOUSER header marked YTB-P5.
h. 5-pin connector from TILT header marked YTB-P3.
j. 4-pin connector from TILT header marked YTB-P4.
k. 4-pin connector from DIM header marked YTB-P13.
m. 8-pin connector from DIM header marked YTB-P12.
n. 4-pin connector from DIFF header marked YTB-P15.
o. 8-pin connector from DIFF header marked YTB-P14.
p. 8-pin connector from FOCUS header marked TB-P16.
Step 4. Remove yoke termination board (
Figure 3-22
).
Step 5. Remove lamp assembly.
a. At lamp assembly, turn 1/4-turn fasteners on rear of lamp
assembly and carefully slide out lamp assembly from
luminaire head (
Figure 3-19
).
Step 6. At lamp carriage, squeeze and lift lamp retainer. Remove lamp
from carriage.
Step 7. Remove blue/amber bulkhead (
Figure 3-1
).