C
HAPTER
2. I
NSTALLATION
& C
HECKOUT
2-7
02.9628.0010 CONFIDENTIAL
7-Oct-97
2.2 Checkout
Use this procedure to verify proper equipment operation.
2.2.1 Power-Up
Step 1. Connect luminaire to a
VARI*LITE Series 200
console
through an ACS rack or truss repeater.
Step 2. Supply system power to luminaire.
Step 3. Watch for luminaire calibration. If luminaire does not calibrate,
check lamp cable connection. Refer to Test and Fault Isolation
sections in Chapter 3 as needed.
Step 4. Verify that luminaire responds to control console commands.
(Instructions for exercising luminaire functions should be
referenced from the console operator’s manual.) If luminaire
does not respond properly, refer to Test and Fault Isolation
sections in Chapter 3.
To Next Page
Loading...