VARILITE VL4 - Page 86

3-40
V
ARI
*L
ITE
®
-
VL4
W
ASH
L
UMINAIRE
S
ERVICE
M
ANUAL
CONFIDENTIAL 02.9628.0010
7-Oct-97
Step 4. Install replacement worm wheel and re-assemble luminaire.
a. Replace worm wheel by doing Steps 2 and 3 in reverse.
b. Make sure that worm wheel is aligned properly on drive
shaft so that it engages worm gear in center.
c. Apply small amount of Versilube to drive shaft.
d. If during replacement motor mount bushing or bearing
comes loose, place bead of Superbonder 498 glue around
bushing flange and fully reseat bushing in motor mount.
Allow 15 minutes for glue to dry before re-installing motor
mount.