Advanced Digital Video Platform Hybrid-DVR User’s Guide
IP ADDRESS 1(Ethernet Port): Shows either the manual IP address entered in NETWORK
setup or the IP address assigned by a DHCP server if enabled.
IP ADDRESS 2(Local Port): Shows either the manual IP address entered in NETWORK
setup or the IP address assigned by a DHCP server if enabled.
HYBRID-DVR display two IP address for Ethernet and Local port each.
If same range of IP address used, then HYBRID-DVR can be error.
MAC address 1(Ethernet port): show mac address configured by manufacturer.
Mac address 2 (local port): show mac address configured by manufacturer.
HYBRID-DVR’s display two MAC address for Ethernet and Local port each.
DDNS SERVER ADDRESS: If DDNS is enabled, the host DDNS server is specified here.
HYBRID-DVR SERVICE PORT: port number for HYBRID-DVR network operation
WEB SERVER PORT: The port number that the HYBRID-DVR uses to support remote
connections.
FAN STATUS: Display FAN Speed of internally installed to HYBRID-DVR (RPM).
Cooling fan’s speed is lower than certain level, alarm is occurred.
TEMPERATURE: Display internal temperature of HYBRID-DVR(℃/℉).
SYSTEM NAME: A system name of up to 15 characters can be defined. It is used so that
notification emails can be identified.
F/W UPGRADE: Firmware updates may be released periodically to enhance system
performance and add extra features. The operator can upgrade the firmware using a USB
memory stick.
FACTORY DEFAULT: If settings have been changed which causes erratic behavior, the
factory default settings can be loaded.
SYSTEM DATA: System settings can be saved to a USB memory stick. The settings can
be reloaded in case of accidental factory reset or can be transferred to another HYBRID-
DVR.
Caution) 4ch HYBRID-DVR: USB port is used in front panel.
8/16ch HYBRID-DVR: Below USB port in Front should be used.
VIDEO STANDARD: You can select Video Signal and selected video signal will be
adapted as main value automatically.
If you change the video signal, the power of HYBRID-DVR will be OFF/ON.
AUTO LOGIN (PASSWORD): Selects if a password is required „ON / OFF‟.
Note) Password must be selected to ‘ON’ if USER MANGEMENT options are required.
To Next Page
Loading...