Name: Verint nextiva V4320 series
Brand: Verint
Rating: 5 (1 reviews)

To Next Page

To Previous Page

I/OConnections

The camera equips one alarm input and one relay output for alarm application.

Pin Signal

1 Alarm In -

2 Alarm In +

3 Alarm Out -

4 Alarm Out +

5 Audio Out R

6 Audio Out L

7 Audio GND

8 Audio In R

9 Audio In L

Installing the FDModel

Caution

Verint will not be held liable for damages to persons or property due to the

improper installation of the Nextiva IP cameras.

► To install on a surface

1. Remove the dome cover using supplied security screwdriver.

2. Attach the supplied alignment sticker to the surface.

3. Drill two pilot holes into the surface.

4. Hammer the supplied plastic anchors into the holes.

5. Secure the camera to the ceiling with a screwdriver.

6. Remove the two protective sponge rings protecting the lens and lens hood.

7. Reattach the dome cover.

Note

Insert the micro SDcard into the card slot before turning on the camera. If the

camera is on, reboot the camera after inserting the micro SDcard.

Chapter 1: Nextiva V4320Series Overview

Questions and Answers:

Need help?

Do you have a question about the Verint nextiva V4320 series and is the answer not in the manual?

Verint nextiva V4320 series Specifications

General