Setting the Tampering Alarm
► To set tampering alarm
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click System > Events > Tampering.
4. Select On , Off or By Schedule.
If you select By Schedule, from the list, select the schedules to run.
5. From the Tampering Duration box, set the number of seconds to wait
before triggering a tampering alarm. The time range is from 10 to 3600
seconds and the default value is 20 seconds.
6. From the Triggered Action section, select the alarm actions to perform.
Choose from the following:
Enable Alarm Output (low/high)
Send Message by FTP/E-Mail
Send HTTPnotification.
Upload image by FTP
Upload image by E-Mail
7. Click Save.
Setting the Tampering Alarm
47 © 2014 Verint Systems Inc. All Rights Reserved Worldwide.
To Next Page
Loading...
Need help?
General
