Configuring the SD Card
Use the Storage Management tab from the web page to view storage status and
configuration of the SD card.
► To configure local recording
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click System > Storage management.
4. Select Enable automatic disk cleanup to remove video based on the
time and storage limit.
Note
If automatic disk cleanup is not enabled, the recording will stop when the
SD card gets full.
5. Set the number of days or weeks to wait before deleting video.
6. Set the percentage of disk space used before deleting the oldest video.
Note
To extend the life expectancy of the SD card, Verint recommends setting
the disk cleanup to 85% or lower as per SD card manufacturer
recommnedations.
7. Click Save.
Note
First disk clean up is done based on the number of days or week set. If the
SD card is still over the maximum percentage, clean up will be done by
deleting the oldest files (up to seven files at the same time).
8. From the recording list section, you can view, sort, remove and download
individual video files.
Chapter 4: Advance Configuration
© 2014 Verint Systems Inc. All Rights Reserved Worldwide. 50
To Next Page
Loading...
Need help?
General
