Safety
Always observe the following precautions to reduce the risk of injury and
equipment damage:
Installation and service should be performed only by qualified and
experienced technicians and comply with all local codes and rules to
maintain your warranty.
Wipe the camera with a dry soft cloth. For tough stains, slightly apply with
diluted neutral detergent and wipe with a dry soft cloth.
Do not apply benzene or thinner to the camera, which may cause the
surface of the unit to melt or the lens to fog.
Do not touch the Nextiva IP cameras during a lighting storm.
Only use the recommended power cable for powering the Nextiva IP
cameras. If you are unsure of the actual power requirements, please
contact the distributor and do not connect the power at will.
The power cable must be properly secured as improper connections may
cause a short.
Turn off the Nextiva IP cameras as soon as smoke or unusual odors are
detected.
Do not place the Nextiva IP cameras near a heat source.
Keep the indoor Nextiva IPcameras models away from water. If they
become wet, turn off immediately.
Do not place the indoor Nextiva IPcameras models in a high humidity
environment.
Do not place the Nextiva IPcamera on an unstable cart, tripod, or on a
tabletop as personal injury and damage to the unit may occur due to a fall.
Please use officially certified support, frames, and accessories included with
the product. Follow the instructions in this Instruction Manual during
installation to ensure the quality and maintain safety.
Keep the Nextiva IP cameras away from direct sunlight, except for outdoor
models.
Do not disassemble the Nextiva IP cameras.
Do not drop the Nextiva IP cameras.
Do not insert sharp or tiny objects into the Nextiva IP cameras to avoid
short circuits.
Operating temperature
Nextiva Model Operating Conditions
Nextiva V4320BX-DN 0°C to 40°C (32°F to 104°F), with maximum
© 2014 Verint Systems Inc. All Rights Reserved Worldwide. 5
Safety
To Next Page
Loading...
Need help?
General
