Verint nextiva V4320 series User Manual

Viewing Information
► To view information
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click System > View information.
4. Click Log file to view system logs.
5. Click User information to view information about the users.
6. Click Parameters to view information about the current settings of the
IPcamera.
7. Click Access list to view access information.
Performing a Factory Default
The IP camera comes with the following factory default values:
IP Address: DHCP enabled. If the DHCP configuration fails, the IP camera
assigns itself a temporary APIPA address: 169.254.X.Y. (where X and Y are
based on the last two octets of the MAC Address.
Username and Password: admin
► To perform a factory default
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click System > Maintenance.
4. From the Factory Default section, click one of the following:
Full Restore:To completely restore to the factory default settings.
Partial Restore: keeps network configuration.
Note
Click Reboot to restart the IPcamera without changing current settings.
Viewing Information
53 © 2014 Verint Systems Inc. All Rights Reserved Worldwide.

Verint nextiva V4320 series Specifications

General

Brand	Verint
Model	nextiva V4320 series
Category	IP Camera
Language	English