Configuring Motion Detection
Motion Detection function allows detecting suspicious motion and triggering
alarms when motion volume in the detected area reaches / exceeds the
determined sensitivity threshold value.
The function supports up to four sets of Motion Detection Settings.
► To configure alarm inputs
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click System > Events > Motion Detection.
4. From the Motion Detection list, select the motion set.
5. Select On , Off or By Schedule.
If you select By Schedule, from the list, select the schedules to run.
6. From the Motion Detection Setting section, set the following:
Sampling pixel interval.
Detection level
Sensitivity level
Time interval
7. Click Add to add a motion detection window on the live video pane. You can
add up to ten windows in each set of Motion detection settings.
8. To change the size of the Motion Detection Window, move the mouse cursor
to the edge of the frame and draw it outward / inward. Moving the mouse to
the center of the frame can shift the frame to the intended location.
9. From the Triggered Action section, select the alarm actions to perform.
Choose from the following:
Enable Alarm Output (low/high)
Send Message by FTP/E-Mail
Send HTTPnotification
Upload image by FTP
Upload image by E-Mail
10. Click Save.
Configuring Motion Detection
45 © 2014 Verint Systems Inc. All Rights Reserved Worldwide.
To Next Page
Loading...
Need help?
General
