Setting Audio
► To set audio
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click Video >Audio.
4. From the Transmission Mode sections, select one of the following:
Full-duplex (Talk and Listen simultaneously):In the Full-duplex mode,
the local and remote sites can communicate with each other
simultaneously, i.e. both sites can speak and be heard at the same time.
Half-duplex (Talk or Listen, not at the same time):In the Half-duplex
mode, the local / remote site can only talk or listen to the other site at a
time.
Simplex (Talk only):In the Talk only Simplex mode, the local / remote
site can only talk to the other site.
Simplex (Listen only):In the Listen only Simplex mode, the local /
remote site can only listen to the other site.
Disable:Select the item to turn off the audio transmission function.
5. From the Server Gain Setting section, set the audio input/output gain
levels for sound amplification. The values are adjustable as follows:
Output Gain: 1 to 6
Input Gain: 1 to 10.
6. Click Save for each option.
Chapter 2: Configuration
© 2014 Verint Systems Inc. All Rights Reserved Worldwide. 28
To Next Page
Loading...
Need help?
General
