Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
352
Introduction of various types of call-queuing (incoming/making /talking/held call) buttons
• DSS button :
Assignment of a specific station number
Call-queuing from/to the specific station number
Presence of the station status
• CO channel button :
Assignment of a specific CO channel
Call-queuing for an external calling/receiving/held call via the the specific CO
channel
Presence of the CO channel status
• CO-Group button :
Assignment of a specific CO-group number
Call-queuing for an external calling/receiving/held call via the the specific CO-Group
Presence of the queued call on the button
• CO-LOOP button :
Assignment of a special type 'LOOP' for non-specific/random/whole-range of CO
channels
Call-queuing for an external calling/receiving/held call via the button
Presence of the queued call on the button
• MSN-LOOP button :
Assignment of a external DID telephone number
Call-routing of an incoming external call with called party number to stations who
have MSN LOOP buttons with same DID telephone number as the incoming called
party number
Call-queuing and presence of status of the incoming external call
Call-queuing and presence of status of an outgoing external call which was created
on the button when make a call by pressing the button.
Multiple buttons assignment with same or different MSN telephone number
An option : MSN Wait = OFF/ON (second incoming MSN routing call allow = yes/not)
• Unified-LOOP button :
Assignment of coverage of my station number
Multiple buttons assignment
A button can have an receiving/making/held call for both type of internal and external
call
DSS/CO/CO-Group/CO-LOOP/MSN-LOOP button goes first than Unified-LOOP
button
(An incoming call is presented on related DSS/CO/CO-Group/CO-LOOP/MSN-
LOOP button at first, the call is presented on an Unified-LOOP button at second
priority)
Do not need to enable "call-coverage-mode" feature for utilization of this button.
Operation
iPECS IP & LDP Phones
Keyset
To assign a {Call Wait} button:
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “34” + [HOLD/SAVE]
To activate/deactivate call wait
1. Press the {Call Wait} button.
2. Dial activate/deactivate code, “1” or “0” respectively.
To Next Page
Loading...
