Vetus EC3 - 1 Actuator: Solution D Configuration

To Next Page

To Previous Page

030624.13 33

vetus® Electronic engine remote control

7.4 Installation with 1 actuator – solution D

The actuator is placed at one end of the CANBus network.

This installation scheme is valid for systems with:

• up to 3 command stations and 1 engine with mechanical throttle, mechanical gearbox, with/without trim (or flap);

• up to 3 command stations and 1or 2 engines with electronic throttle (voltage or CANBus), mechanical gearbox, with/

without trim (or flap);

• up to 3 command stations and 1 or 2 engines with electronic throttle (voltage or CANBus), solenoid driven gearbox,

with/without trim (or flap);

Code: DTCANxx

JP19: ON (end-line)

JP14: OFF (address)

Actuator

Data transmission cable

Command station 2 Command station 3Command station 1