Vetus EC3 - Electronic Engine & Electronic Gearbox Programming

72 030624.13
vetus® Electronic engine remote control
14 Programming of actuators with electronic engine and electronic
gearbox
14.1 Electrical wiring
For electrical wiring please refer to chapter 8.
14.2 Specific parameters
Installations with electronic gearbox might require a delay time when you pass the lever directly from reverse to
forward or from forward to reverse. Factory setting is 0,5 seconds.
Display
code
Description Values
Factory
value
Value shown on dis-
play (factory value)
Note
dI Delay in switching off the gearbox 0 .. 9,9 s 0,0 s 00
dA Delay in start of throttle 0 .. 9,9 s 0,0 s 00
dF
Delay in neutral; it occurs any time you
move directly from forward to reverse or
from reverse to forward. This delay does
not occur when from neutral you move
to forward or reverse.
0 .. 9,9 s 0,5 s 05
L1
These parameters are present only in system with electronic engine with ECU and/
or electric engine inverter driven. Parameters for the voltage outputs are described at
section 12.3.2.
H1
C1
L2
H2
C2
L3
H3
C3
L4
H4
C4
CC To be used for the check-up of the internal CANBus communication