Vetus EC3 - Electronic Engine & Mechanical Gearbox Programming

To Next Page

To Previous Page

64 030624.13

vetus® Electronic engine remote control

12 Programming of actuators for installations with electronic engine

and mechanical gearbox

System’s components involved: push-pull cables, actuator

In this chapter it will be presented how to program the actuator, in order to obtain the correct strokes of gearboxes. De-

pending if the boat is with 1 or 2 propulsion systems, the actuator looks according one of the pictures here below:

You must program either 3 or 6 positions and consequently 3 or 6 parameters: 3 for per each gearbox, according to the

parameters of the above table.

Parameter

Value on

display

Function

Gearbox 1

(right)

0L Gearbox Reverse

0F Gearbox Neutral

0H Gearbox Forward

Gearbox 2

(left)

1L Gearbox Reverse

1F Gearbox Neutral

1H Gearbox Forward

Actuators are delivered from factory with Forward, Reverse and Neutral positions coincident in the Neutral position.

Therefore the installer must do the correct setting the stroke, in order to start-up correctly the system.

0H1H

Gearbox

Left gearbox Right gearbox

Push Pull