Vetus EC3 - Specific Parameters

030624.13 63
vetus® Electronic engine remote control
System with mechanical throttle and mechanical gearbox
UL 0L
0F
0HUH
Gearbox
Throttle
Push Pull
Push Pull
Problem Solution
The gearbox push-pull cable positions
are inverted (forward and backward po-
sitions are inverted) while the throttle
push-pull cable works correctly
Set A0=3
The gearbox is working correctly while
the throttle push-pull cable positions
are inverted (min and max throttle po-
sitions are inverted)
Set A0=1
Both gear or throttle push-pull cables
positions are inverted
Set A0=2
11.3 Specific parameters
Display
code
Description Values
Factory
value
Value shown on dis-
play (factory value)
Note
A0
Push-pull cable movement direc-
tion
1 .. 4 4 04
dI
Delay before disengaging the
gearbox
0 .. 9.9 s 0.0 s 00
dA Delay on the throttle 0 .. 9.9 s 0.0 s 00
PP Proportional coefficient 0 .. 99 40 40 These para-
meters must not
be modified
PI Integral coefficient 0 .. 99 0 00
CC To be used for the check-up of the internal CANBus communication
The following examples show how to operate in case there is not the exact correspondence between the command lever
and the actuator.