Vetus EC3 - Page 5

030624.13 5
vetus® Electronic engine remote control
12 Programming of actuators for installations with electronic engine and mechanical gearbox ...........64
12.1 Programming of the gearbox strokes ..........................................................65
12.2 Sea trials ......................................................................................67
12.3 Specific parameters ...........................................................................69
12.3.1 Parameters to configure the voltage output signal for electronic engines ...............69
12.3.2 Parameters to configure the voltage output signals ....................................70
13 Programming of actuators for mechanical engines and electronic gearbox ...........................71
13.1 Mounting of the engine the push-pull cable and programming of throttle mechanical strokes ...71
13.2 Programming of the push-pull cable strokes ...................................................71
13.3 Electrical cabling of the gearbox ...............................................................71
13.4 Specific parameters ...........................................................................71
14 Programming of actuators with electronic engine and electronic gearbox ............................72
14.1 Electrical wiring ...............................................................................72
14.2 Specific parameters ...........................................................................72
15 System configuration in case of options .............................................................73
15.1 Commissioning of actuators for installations with Trim or Flap command option ................73
15.2 Commissioning of actuators for installations with Trolling option ...............................73
15.3 Commissioning of the actuators with Neutral Relay option .....................................73
16 Trouble shooting ...................................................................................75
16.1 What to do in case of system failure ............................................................75
16.1.1 Behaviour of the system in case of unforeseen shutdown ...............................75
16.1.2 Emergency lever and how to overcome faults during navigation in case of system
with mechanical interface .............................................................75
16.1.3 Self-protection in case of overload or breakage of the push-pull cables .................76
16.2 Analysis of the electronic system behaviour ....................................................77
16.3 Diagnosis through the command station ......................................................79
17 Drilling mask for command stations .................................................................80
17.1 Command station series EC3 ..................................................................80
17.2 Command station series EC4 ..................................................................81
18 Drilling mask for actuator ...........................................................................82