VR Technology Limited
How to enter a PIN
PINs are keyed in using the switches and are logged in on the bottom line of the Pin
Num screen. A short push on a switch will move the number highlighted by 1; a long
hold will move it by 8. When keying in each digit or letter move forwards using the
right hand + switch. Do not move backwards using the left hand - switch except to
correct, as this may cause previously entered numbers to change. After you have
keyed in the last digit of your PIN there will be a pause before the cursor moves to the
top of the screen you can use the left and right switches to key in your name and
phone number, or any other data you wish, in order to identify the VR computer as
yours, (see below).
After a PIN has been successfully installed the bottom line of the screen will revert to
16 zeros.
Security and Trace-ability
A key benefit of the PIN system is the security and trace-ability it offers. In order to
change or remove the identifying particulars you have installed, someone would need
one of your PINs so keep them in a safe place away from your VR. Then, if your
computer is ever lost or stolen, notify us and, as your identifying particulars will still
be there on the screen, we can look out for it in the event that it ever comes in to us
for repair or upgrade. Also don’t forget to write to us and register ownership via our
website, www.technologyindepth.com/vrx.html. If you lose your PIN(s), we can only
reissue them to you if we have you listed as the owner. If you should ever sell on your
computer, you will need to give the new owner the PINs so that the security
information can be changed.
VR Dive Computer Operations Manual 2009 rev E 28/01/2009
11
To Next Page
Loading...