VR Technology Limited
Congratulations on your purchase of a VR dive computer.
You are going to have a lot of fun learning how to use your new VR.
Your VR has been delivered to you in G10 mode. This is the latest version of VR
software and, we believe, represents a considerable advance over earlier versions.
If you prefer, you can run the VR in G3 mode which is almost identical to G10 mode
but only allows you to preset three gases in the gas list and has a simpler user
interface.
You can also operate the computer in X10 mode which takes the VR back to the 2007
version of the software (see website for details, Support, manuals). This might be
preferred by VR owners with long experience of the computers and who have reached
the point where they have an instinctive acquaintance with the way the computer used
to work and prefer not to learn new navigation techniques.
Your VR is delivered to you in multicolour mode. If you have ordered the multicolour
upgrade from new then of course multicolour mode will be permanent. If you have
ordered a single colour VR you will be able to enjoy multicolour mode for your first
three dives so you can see what it looks like before your computer reverts to single
colour mode. If you then decide you preferred multicolour mode just call your dealer
and buy the multicolour upgrade PIN and install it.
VR Dive Computer Operations Manual 2009 rev E 28/01/2009
6
To Next Page
Loading...