VYBO Electric Vector V800 - Page 10

Chapter 1: Technical parameters
4
Parameter
VECTOR V 800
Standard functions
DC braking
Braking frequency: 0.3 Hz to maximum frequency
Braking time: 0.0-100.0 s
Braking current: 0.0% -100.0%
Control in JOG mode
(stepping)
JOG frequency range: 0.00-50.00 Hz
JOG acceleration / deceleration time: 0.0-6500.0 s
Preset fixed speeds
Implemented up to 16 speeds using a simple PLC function
or combinations of end states X.
Built-in PID controller
Facilitates a process-driven closed-loop control system.
Automatic voltage
control AVR
When changing the supply voltage, it can automatically
maintain a constant output voltage.
Overvoltage and
overcurrent control
Current and voltage are automatically limited during
operation to prevent frequent tripping due to overvoltage
and over current.
Torque limitation
and control
It can automatically limit the torque and prevent frequent
over current during run.
STO safety
function
"Emergency stop" system: In emergency situations, the
inverter stops immediately after activating STO.
Speed limitation of
current
It helps to prevent frequent errors due to over current of
the AC motor
High power
AC motor control is realized by high power vector current
control technology.
Time management
Time range: 0.0-6500.0 minutes
Communication
protocol
RS485 MODBUS RTU
Channel of trigger
commands
According to the panel, control terminals, the serial
communication port can be switched in many ways.
Frequency source
10 kinds of frequency, given by digital analog voltage,
analog current, pulse, serial port, can be switched in many
ways
Auxiliary source of
frequency
10 kinds of frequencies, micro adjustment can be easily
realized, frequency synthesizer