BA 1001/1501/2001 us – Edition 3.3 * 12001b210_us.fm 2-15
Safety Information
Gas, dust, steam, smoke
• Operate the machine only on adequately ventilated premises! Before starting internal
combustion engines or operating fuel-operated heating systems on enclosed premises,
make sure there is sufficient ventilation!
Observe the regulations in force at the respective site!
• Perform welding, flame-cutting and grinding work on the machine only if this has been
expressly authorized. There can be a risk of explosion and fire, for example!
• Before performing welding, flame-cutting and grinding work, clean the machine and its
surroundings from dust and other inflammable substances, and make sure the
premises are adequately ventilated – explosion hazard!
Hydraulics
• Service on the hydraulic equipment of the machine must be performed only by persons
having specific technical knowledge and experience in hydraulic systems!
• Check all lines, hoses and screw connections regularly for leaks and obvious damage!
Repair any damage and leaks immediately! Splashed oil can cause injury and fire.
• In accordance with the Operator's Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to be
opened before performing any maintenance/repairs!
• Hydraulic and compressed-air lines must be laid and fitted properly. Make sure no
connections are interchanged. The fittings, lengths and quality of the hoses must
comply with the technical requirements
• Check all lines, hoses and threaded fittings regularly for leaks and obvious damage!
Repair any damage and leaks immediately. Leaking oil may cause injury and fire!
Noise
• Close all sound baffles during operation.
• Wear ear protection. This is especially important when performing hammer operations
or working in enclosed areas.
Oil, grease and other chemical substances
• When handling oil, grease and other chemical substances (e.g. battery electrolyte –
sulphuric acid), observe the product-related safety regulations (safety data sheet)!
• Be careful when handling hot consumables – burn hazard!
MSDS
• When handling oil, grease and other chemical substances such as battery electrolyte or
hydraulic fluid, observe the product-related safety regulations (Material Safety Data
Sheet: MSDS).
To Next Page
Loading...
Need help?
General
